|
|
How can I set the length of time capture. For instance I want to record 10s of signals on the scope. I tried about everything but couldn't figure it out and the manual is just plain terrible.
The "Time" is the time from one vertical bar to the next so that isn't it.
Under "More" you can set "Fixed Sample" but that seems to be the sample rate. If I set it to 48M then I can only capture about 136ms. When I set it to 1M I would expect that I can capture 48x more time (same number of sample points), i.e. about 136*48=6.5s. However, no matter what I set for the sample rate I cannot get more than approx. 1s. Even if I go down to 1k sample rate I still just get 1s, just with a worse resolution. So how can I get to 10s or more? |
|
Post time 2022-6-10 02:50:23